3n38 powder No Further a Mystery

3n38 powder No Further a Mystery

Blog Article

By subscribing you agree to our privacy plan and will be the initial to learn about promotions, special features and item releases.



We emphasize on the caliber of our coffee as on our excellent of provider, delivering our clients with full versatility to cover their wants continually.

Reviews can only be submitted whilst remaining logged in. Make sure you enter your login specifics down below. New purchaser?

I have wondered about Alliant Steel for giant pistol conditions (.forty four Mag and scorching .forty five Colts) but I believe the situation is the flakes are far too large and you also'd have to weigh just about every cartridge. :barf:

I agree, Never run off reaming anything until finally you have loaded sufficient to generally be assured with your stack top.

And Sure, I've used all three powders, and will fall flats of these on stations in mixes, and you would not have the ability to explain to which shell experienced what powder, since the speeds and patterns are so close together with the 1350fps assortment, there is no practical change in general performance in the shells.




Five pellet loads of OOO can be a bit iffy due to the fact based upon exact diameter and alloy from the pellets just one is using the overall load bodyweight of all 5 pellets can exceed three/four-oz.

So In the event your not about to ream the shot bushing and just Allow it toss 214grs of shot, then up the powder bushing to your .three hundred" ID bushing from the HS loads. This extra little little bit of powder will give the shell the necessary quantity useful site to fill it fully, so the shot will not rattle after crimp.

Now Alternatively, In case the hulls are HS, then the powder bushing you need should have an ID of .296" and a concentrate on pounds drop of 16.9grs, which need to set the shell all around 1325fps, and which is able to pattern a hell of lot much better than one at 1200fps isntead.

Hence at 1200fps, the 410 with its lengthy and slim shot column will sizzling spot center, although the amplified speed allows the center pellets to fill out the pattern, in lieu of incredibly hot location centering isntead.

3 grains. Similar batch of boolits showed less stress with 410 through Sept./Oct. I under no circumstances had the chance to Your Domain Name implement it within the chilly with the Winter season nevertheless. I truly appreciated it greater than 2400 due to the fact I could squeak out extra velocity right before main would established in...

Your rammer tube may very well be set as well minimal. I have not loaded .410, but I suspect that the 30 lb. you should move the indicator is an excessive amount of for your .410 wad. Try ramming a wad with the clamp unfastened and see if the rammer tube moves up. If it does, consider a crimp. If that's as well high, reduce and champ the tube about 50 % way.




The best ballistic professionals and high high quality components are brought with each other to make sure every gun is best served with Accurate Powders.

Observe: Will not rely on the charts!!!! Do some throws Along with the new bushing with your device and pounds the throws to substantiate that you're obtaining the proper grain drops.